Removing links from sb3

[john10001]

Can anyone advise on how to remove links on the SB3? Can you do it with small screwdriver or do you need to buy a special tool?

Thanks,
John

[dforgrieve]

You will need two small screwdrivers, something soft to lay the watch on and a steady hand.

I think there is a special tool available if you prefer.

Dave

[john10001]

You will need two small screwdrivers, something soft to lay the watch on and a steady hand.

I think there is a special tool available if you prefer.

Dave

Thanks. What do you do then, is it just a case of pushing inwards at both sides? I think it is all one bar that connects the links isn't it?

John

[kfman]

Simply hold one whilst turning the other to undo the thread on the pin.

[Online]

The bar runs all the way through. It's slotted at one end and has a threaded hole at the other for the retaining screw. This is very small, so be careful you don't lose it. You really need three hands - one to hold the bracelet down and one each for the two screwdrivers.

[Bry1975]

Have you got any strong double sided tape?

[Dave E]

Two small screwdrivers, some patience and some care, that's all that is needed. It's a bit fiddly, and best done in a calm frame of mind, but that's it!

[Glamdring]

It requires Zen and Zantac. One for the mind and the other for your stomach when the screw hits the carpet. ;)

If I did it successfully anyone can.

[john10001]

I've got it clocked. Had to remove 4 links but it fits perfect now. Thanks!

Now... Can anyone recommend what tool to get for when I want to remove the bracelet and try other straps on it?

John

[Dave E]

Well done! You will need a Bergeon spring bar tool with a fine end to change the bracelet :)